Q-TEL 2052 B SEALANT 3 OZ TUBE 79500 **MINIMUM ORDER OF 12***
Available*
Item # 58080000
Model # 2052
$8.80
financing available. Learn More
* Notes on Availability:
If item is in stock, it will ship same day.
Lead times vary, contact us for more info.
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
Compound
Material and Supplies
Closures
Closure Accessories Replacement Parts
Q-Tel
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
Q-TEL 2052 B SEALANT 3 OZ TUBE **MINIMUM ORDER OF 12*** NEW
B-SEALANT is a one-component silicone adhesive/sealant which cures when exposed to air. Being a moisture cure material, it is widely used in the outside plant where its rapid formation of a skin is an advantage. The filling of gaps where drop wires or optical fibers pass through split grommets in pedestals and terminals is one example. Its non-sag property allows it to be used to fill gaps on vertical surfaces and to repair gaskets and seals.
As an RTV silicone, the uncured material is often used as a lubricant/sealant in placing and holding stopper-type grommets. Even though the outer surface becomes dry to the touch within minutes of exposure to moisture, the inner material will remain soft enough to allow for fit up, hours after application.
B-SEALANT has been used to insulate and waterproof connections on distributed electronics. It is tested for the suitability of both power and signal electrical properties. B-SEALANT is not flame retardant.
Silicone rubber remains pliant throughout its service life and does not age, harden, or crack as do natural or synthetic rubbers. It is an alkoxy cure material and does not give off corrosive vapors. There have been no reported incidences of incompatibility with the standard materials of construction found in the plant.
B-SEALANT has been tested and approved by independent labs and meet Bell Operating Company Specification CA08502.
Use B-SEALANT for: Sealing grommets Drop wires Premise entry points Fill gaps Repair gaskets and seals Adhering ducts, joints, electrical wires, and connectors End capping
B-SEALANT is a one-component silicone adhesive/sealant which cures when exposed to air. Being a moisture cure material, it is widely used in the outside plant where its rapid formation of a skin is an advantage. The filling of gaps where drop wires or optical fibers pass through split grommets in pedestals and terminals is one example. Its non-sag property allows it to be used to fill gaps on vertical surfaces and to repair gaskets and seals.
As an RTV silicone, the uncured material is often used as a lubricant/sealant in placing and holding stopper-type grommets. Even though the outer surface becomes dry to the touch within minutes of exposure to moisture, the inner material will remain soft enough to allow for fit up, hours after application.
B-SEALANT has been used to insulate and waterproof connections on distributed electronics. It is tested for the suitability of both power and signal electrical properties. B-SEALANT is not flame retardant.
Silicone rubber remains pliant throughout its service life and does not age, harden, or crack as do natural or synthetic rubbers. It is an alkoxy cure material and does not give off corrosive vapors. There have been no reported incidences of incompatibility with the standard materials of construction found in the plant.
B-SEALANT has been tested and approved by independent labs and meet Bell Operating Company Specification CA08502.
Use B-SEALANT for: Sealing grommets Drop wires Premise entry points Fill gaps Repair gaskets and seals Adhering ducts, joints, electrical wires, and connectors End capping
