OPTIX AMERICA 1XSOC-HEATER External Heater for 1X Splice-on Connector
Available*
Item # 53760675
Model # 1XSOC-HEATER
$108.00
financing available. Learn More
* Notes on Availability:
If item is in stock, it will ship same day.
Lead times vary, contact us for more info.
(Images may not be of the actual item being sold.)
- Product Description
- You Might Also like
- Recently Viewed
Generic
Class
Group
Type
Manufacturer
LOT
Connector
Fiber Optic Products
Fusion and Mechanical Splicing
Fiber Fusion Splicer
Optix America
Fiber Splice On Connectors
Warning: This product can expose you to chemicals, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.govProduct Description
OPTIX AMERICA 1XSOC-HEATER External Heater for 1X Splice-on Connector
OPTIX AMERICA 1XSOC-HEATER External Heater for 1X Splice-on Connector
External HEATER for 1X Splice-on Connector Only 7 seconds to shrink protection sleeve - Designed to heat shrink protection sleeves more quickly than typical fusion splicer heaters - Ideal Solution for fusion splicer heating chamber too small to accommodate one-piece design splice-on connectors.. - 3.0 amp motor can reach over 600 degrees Fahrenheit - Airflow of 300 L/Min within seconds to make your work more efficient. - An over-heat protection will shut the unit off automatically when temperature reaches the upper limit. - Made of high quality impact-resistant PA6+30GF body and with nozzle safety shield to ensure maximum security for you.
Specifications Material PA6+30GF & Stainless Steel Nozzle Rated Power 50W Air Flow 300 Liters per Minute Weight .38 Kg Rated Voltage 110V-60Hz Temperature 662?/350? (one temperature setting) Cord Length 1.5m Product Dimensions 10.43 x 3.35 x 2.76 inches Voltage 110 Volts
OPTIX AMERICA 1XSOC-HEATER External Heater for 1X Splice-on Connector
External HEATER for 1X Splice-on Connector Only 7 seconds to shrink protection sleeve - Designed to heat shrink protection sleeves more quickly than typical fusion splicer heaters - Ideal Solution for fusion splicer heating chamber too small to accommodate one-piece design splice-on connectors.. - 3.0 amp motor can reach over 600 degrees Fahrenheit - Airflow of 300 L/Min within seconds to make your work more efficient. - An over-heat protection will shut the unit off automatically when temperature reaches the upper limit. - Made of high quality impact-resistant PA6+30GF body and with nozzle safety shield to ensure maximum security for you.
Specifications Material PA6+30GF & Stainless Steel Nozzle Rated Power 50W Air Flow 300 Liters per Minute Weight .38 Kg Rated Voltage 110V-60Hz Temperature 662?/350? (one temperature setting) Cord Length 1.5m Product Dimensions 10.43 x 3.35 x 2.76 inches Voltage 110 Volts
